how to replace oil filter for diesel generator

    2016-10-11 15:21:46 The oil filter on the diesel generator should be always replaced every several months. Then we will take china diesel generator as an example, to explain how to replace it.
    In fact, the installation of diesel filter on china diesel generator is extremely simple, use only according to the oil inlet and outlet interface reserved the series on an oil pipeline. Pay attention to the direction of the arrow shown in the direction of oil import connection cannot be reversed. The initial use and replacement of the filter element, should pay attention to the exhaust, the exhaust valve in the barrel end cover. Second, the replacement of the filter element: under normal circumstances, if the pre filter pressure difference alarm alarm or cumulative use of more than 3000 hours, which should replace the filter, double barrel parallel pre filtering device replacement of the filter element can be without stopping the machine. Third, replace the filter method: 1, single barrel pre filtering device filter element replacement: shut down into the oil inlet valve, open the upper cover. (aluminum alloy type upper cover using a flat screwdriver from the side gap, gently pry) II unscrew the drain plug wire, dirt and oil. The upper end of the fastening nut loose filter, oil filter operator wearing gloves clenched vertically, remove the old filter. The new filter element, the sealing ring pad good upper (lower comes seal), tighten the nut. The tighten pollution outlet plug, cover cover (note pad ring), good fastening bolt. 2, double barrel parallel pre filtering device filter element replacement: first off need to replace the filter side filter oil inlet valve, a few minutes after the closure of the valve, and the lower end of the screw cap bolt, open end cover. The drain valve is opened, completely drain the waste oil, waste oil to prevent the replacement of the filter element into the oil chamber. The upper end of the fastening nut loose filter, oil filter operator wearing gloves clenched vertically, remove the old filter. The new filter element, the sealing ring pad good upper (lower comes seal), tighten the nut. The drainage valve is closed, the cover top cover (note pad ring), good fastening bolt. The first open inlet valve, then open the exhaust valve, exhaust valve oil immediately close the exhaust valve, then open the oil valve. And then in the same way to operate on the other side of the filter.

    Before:some notes about using oil filter for diesel generator

    Next:Method for starting diesel generator in winter

    if you want more understanding, please contact us +86 15905360231 +86 536 8185702

    Address:Xinzheng Industrial Park,Qingyuan West Street,Weifang Economic Development Zone,Shandong Province,China

    Mobile:+86 15905360231
    Tel: +86 536 8185702
    Email: hqpower@huaquanpower.com
    Skype:huaquanpower
    Wechat: +86 15905360231
    Whatsapp/Viber:+86 15905360231
    Copyright 2016 HQ-POWER All Rights Reserved. (zhou)