Drying method of synchronous generator

    2017-12-05 14:19:48 Drying method of synchronous generator
     
    Methods: 
    1) caused by hot air balloon blowing hot air dry and clean waste generator, the stator and rotor winding is dry. In order to prevent shaft deformation, we shall be regularly to the rotor rotating 180 degrees. Dry, winding surface temperature should be controlled. Thermometer, winding surface shall not exceed 85, inlet temperature shall not exceed 90 degrees. 
    generator
    2) drying: short circuit current generator output through the short circuit current table, adjust the rotor excitation current, the stator current in each phase is 50-70% of the rated current. Generator rated speed can not run, but should maintain a constant speed, so as to avoid temperature instability. 
    -------------------------------------------------------------------------------------
    TEL: +86 536 8185702
    Mob:+86 15905360231
    SKYPE: huaquanpower
    Wechat/whatApp:+86 15905360231
    EMAIL: hqpower@huaquanpower.com
    ADD: Xinzheng Industrial Park,Qingyuan West Street,Weifang Economic Development Zone,Shandong Province,China
    --------------------------------------------------------------------------------------
     

    Before:Familiar with to learn the structure of the generator and operating procedures

    Next:Last page

    if you want more understanding, please contact us +86 15905360231 +86 536 8185702

    Address:Xinzheng Industrial Park,Qingyuan West Street,Weifang Economic Development Zone,Shandong Province,China

    Mobile:+86 15905360231
    Tel: +86 536 8185702
    Email: hqpower@huaquanpower.com
    Skype:huaquanpower
    Wechat: +86 15905360231
    Whatsapp/Viber:+86 15905360231
    Copyright 2016 HQ-POWER All Rights Reserved. (zhou)